Solas then Rubex brand charts displayed.

Propellers for Yanmar ZT350 Drive, Dual Drive

Manufacturer HP Model Year Range Solas Dealer Locator
Yanmar Stern Drive ZT350 Drive Dual Drive All Years
Dual props may require special tools to install. Please consult OEM manual for proper installation and for torque specs.
Yanmar dual propeller assembly illustration

solas B3 Dual Prop Rear Propeller B3 Dual Prop Rear Propeller
- Excellent acceleration and top speed
- Cupped blade design increases bite & reduces slip
- Highly polished
Stainless - Rear propeller only
3 Blade Propeller - Thru-Hub Exhaust - Solid Hub
Diameter Pitch Rotation Mfg Part Number
14.375 18 R 1651-144-18
14.375 20 R 1651-144-20
14.375 21 R 1651-144-21
14.25 22 R 1651-143-22
14.25 23 R 1651-143-23
14 24 R 1651-140-24
14 25 R 1651-140-25
14 26 R 1651-140-26
13.75 27 R 1651-138-27
13.75 28 R 1651-138-28
solas B3 Dual Prop Front Propeller B3 Dual Prop Front Propeller
- Excellent acceleration and top speed
- Cupped blade design increases bite & reduces slip
- Highly polished
Stainless - Front propeller only
4 Blade Propeller - Thru-Hub Exhaust - Solid Hub
Diameter Pitch Rotation Mfg Part Number
16 18 L 1654-160-18
16 20 L 1654-160-20
16 21 L 1654-160-21
15.75 22 L 1654-158-22
15.75 23 L 1654-158-23
15.5 24 L 1654-155-24
15.5 25 L 1654-155-25
15.5 26 L 1654-155-26
15 27 L 1654-150-27
15 28 L 1654-150-28
Kit #17017501
Thrust Washer Rear Thrust Washer Front Nut Nut
MGFTW MGRTW MGFNT MGRNT
MGFTW MGRTW MGFNT MGRNT
This hardware is for OEM & Solas pressed rubber hub props only (not Rubex).

powered by Rubex prop finder processor v.3.7.2 © Copyright 2010-2020

Notices

• ** Disclaimer: Pitch estimates and propeller selections made by this prop finder are provided only as a general reference and may not be correct for specific boats under actual boating conditions. By using this prop finder, you agree that the Solas Science and Engineering Company, Ltd, its dealers and other host entities do not accept any liability and are not responsible for harm to persons or property, damages or costs caused by the installation, handling or use of an indicated propeller or hardware.

• It is very important to refer to your engine's Owners Manual for important safety precautions when installing a propeller.

• A new propeller's hub and blades must be checked for sufficient lower unit and trim tab clearances before use.

• Wide open throttle RPM, with boat on the water in forward gear under normal loading conditions, should fall within the range that is recommended by the engine manufacturer and not exceed the recommended maximum. This is important in determining a suitable propeller pitch. When in doubt, dealer assistance is suggested.

• Prop installation, inspection and boat operation all need to be done in a safe and responsible manner.

* Trademarks
• Yanmar is a registered trademark of Yanmar Co., Ltd
• Solas is a registered trademark of the Solas Science and Engineering Company, Ltd
• All trademarks remain the property of their respective owners.


Note: Left (L or CCW) rotation is commonly used on single engine boats with this type of drive.